Applies to
All Versions
Topic
Setting a task to
finished in the 3f Software Planner
Prerequisites
You have access to
the 3f Software Planner
See also
Remaining hours on a task
Article
A task is consider to be finished when
there are no more remaining hours left on
it. Therefore, to set the task to
finished the remaining hours for the task
must be said to 0. Setting the remaining
hours to 0 is usually a job done by the
project manager (if you have the
Approval Management module) or if you
do not have that module, whoever is in
charge of the project.
To adjust the remaining hours for task go
to the
Task Remaining Hours Page in the
project management section. All you
have to do is to adjust the remaining
hours across from the task you want to set
to finished. To read more about the Task
Remaining Hours
click
here.
Keyword
finish, finished, set task to finished,
set to finished, set finished, set to
finish, set finish
